The drive system uses a lever that has a special self-locking shutter function to stamp on each piece the same marking.
The force may 'vary thanks to this system from 0 to 950 kg / Force.
The regulation of the force takes place via the knob located in the upper part of the machine.
The temperature is adjusted by digital temperature controller on the front of the machine.
All versions of the above can heat the cliche up to about 250 ° C.
Upon request is available the "BIP" version with acoustic timer.
Standard models
Model 150 standard
Model 150 CO (gold)
Model 150 CS (with sliding table)
Model 150 CSO (with sliding and gold floor)
Specifications
Dimensions 40x65x62 cm.
Net weight 60 Kg about